All virtualization products do not support the underlying functionality that is required to pass the tests that relate to multiple processor groups, device power management, device PCI functionality, and other tests. Windows symbol files. These are available from the Symbol Files website. Turn on the test computer, install the appropriate Windows operating system, install all available Windows updates, and then configure the computer for your test network.
If you have to install the manufacturer-supplied device driver on the test computer, do this now. Make sure that the test computer is in the ready state before you begin your testing.
If a test requires parameters to be set before it is run, a dialog box will appear for that test. Review the specific test topic for more information. Some Windows HLK tests require user intervention. When you run tests for a submission, it is a best practice to run the automated tests in a block separately from manual tests.
This prevents a manual test from interrupting completion of an automated test. When testing storage devices, we strongly recommend that you complete all Device Fundamentals tests before starting storage tests. Storage tests will reconfigure your test device, leaving the device in a state unsuitable to support Device Fundamentals tests.
The following configurations provide steps to create volume on the storage test device. This is important to complete the Device Fundamental part of testing DevFund. Additional information about this Windows Server issue can be found in Microsoft support article kb To avoid the failure, ensure that the secondary iSCSI port cannot reach the target during the reboot in step To do this the user should go to the Boot Options Tab and update the devices' flash to the latest version.
The user has to manually bring up networking through a console. Please refer to the RedHat documentation for details on how to manually force up the network. RHEL 5. On RHEL5. This causes the system to hang and requires a reinstallation at the very least. The workaround for this issue is to edit the init script soon after installation and change the interface you wish to bring up. We strongly encourage our users to use RHEL5. To workaround this, the driver should be built and installed with:.
Contact support. Characters remaining: We appreciate all feedback, but cannot reply or give product support. Please do not enter contact information. If you require a response, contact support. But the HP branded option rom does not work or disables the interactive ctrl-i setup. Thanks, Vasu.
All forum topics Previous Topic Next Topic. Honored Contributor. Kk, I understand. There is only a Linux referencing documentation on this my context was Windows. At server boot 1. Fortunatly, the Linux doc states that: -- 3. Write the boot path to the target server. The boot path configuration file may be written to the target server with the ev DOS utility bios editor or written using the ibootcfg utility. New Member. We probably have to wait until HP releases valid support aka drivers which can be installed via the F6 install procedure.
Regards, Vasu.
0コメント